![]() ![]() Give the rivet something to keep it from expanding far enough to split the plastic, plus keep the edgre from curling up into the plastic. This will help with it splitting the plastic, and will make it easier to pop the rivet shank off. I was contemplating this one which looks more portable:Įbay.com link: Chain Breaker Cutter Master Link Removal Riveter Riveting Press Tool HDīut I think I will try what you advised. WORKPRO 10-Inch Pop Rivet Gun, Heavy Duty Riveter with 3 Interchangeable Heads (3 Nosepieces) and 100pcs Rivets, 5-in-1 Hand Riveter Set for Metal, Plastic, Repairing Truck Bed, Fixing Highway Sign. beowulff: It often helps to put a washer on the back-side of the rivet. Thanks so much, this was a super valuable post to me! Thanks for all the advice Pinsiders, you guys are always so helpful, but I think this is what I will go with. Dont get scammed by websites pretending to be Harbor Freight. The extended slim-nose design allows you to get in those hard to reach areas. The Pin Restore rivet kit also includes washers. The Campbell Hausfeld Pneumatic Pop Rivet Gun (TL053900) is the ideal air tool choice for automotive and construction assembly work. Note that when ever you rivet where the bottom of the rivet would roll over against plastic that you must use a rivet washer. ![]() Pin Restore also sells a nice rivet starter kit ($30). I also have a rivet press, but there are times when the rivet press cannot reach a rivet. You can support the rivet head with a block of wood ( I like to use the jaws on my vise) then just use this tool to hammer against the bottom of the rivet. On the same Pin Restore site indicated above, if you scroll down below the rivet press, you will see a Rivet Roll Over punch ($25). There is a cheaper way to go that will work just as well as the press.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |